Time limit is exhausted. Please reload CAPTCHA. × five = five
CANTY specializes in Mud Flow Analysis as well as Drilling Mud PSA.
Name
Email address
Phone
Inquiry
Features:
• Inline Particle size down to 1µm
• Analysis of oil or water based mud
• Detect oil / water / solids / gas
The CANTY SolidSizer™ is a vision-based sensor used with the CANTY Vector System image processor for dry sand size measurement in a laboratory environment. The CantyVision™ Software accurately measures multiple aspects of the sand from area / perimeter / minor and major axis / etc. In comparison to a sieve which measures only minor axis the CantyVision™ software can correlate directly to a sieve so the customer does not have to change any QC documents. The SolidSizer™ can correlate within 2% of a sieve. A typical sieve analysis takes anywhere from 20-30 minutes including cleaning and setup for a 70-100 gram sample. On the SolidSizer™ that same sample takes less than 2 minutes. Also multiple screen distributions can be setup to accommodate multiple customers or areas in the process, hence eliminating the need for multiple runs on the same sand for different size distributions. After correlating to current methods of minor axis, customers find benefit in comparing minor axis to major axis and making sure the sand is round instead of needle shaped. Reduce lab time and make sure production samples are not skipped over due to lack of sample time available!
• Lab Particle size down to 1µm
• Volume Flow Analysis
• Fluid Front Detection
• Real-Time Viewing
Percent Solids measurement is typically a ratio of the area of solid particles vs the background. As solid percentages increase this can also be done by comparing the ratio of light through an empty cell vs light through a cell with solid content. The analysis is frame by frame at a rate in excess of 30 frames per second, so data can be supplied in very short time intervals (seconds) and produce a steady trend line of percent solids readings vs time.
Within the measurement zone, the particles pass between a high intensity LED light source and camera, which captures high resolution images 2D images. These images are then binarised, and by analyzing the number and position of the image pixels, a full particle SIZE and SHAPE distribution.
Meets ASTM Standards • Polymer Beads / Pellets • Chemical Powders • Particle Size from 10µm to no upper limit*
Monitor phase split in batch mode on organic droplets for increased product recovery. As the droplets appear the system warns of organic phase and the upcoming emulsion. The amount of early droplets and their retraction time will indicate the completeness of the separation. Once the split is identified and stopped, the operator has a visual verification from the video monitor. The color can then be analyzed to ensure there is no inversion.
CANTY manufactures analyzers designed for the measurement of TSS in Brine Completion fluid. Not only does this save significant time and money by eliminating the need to run samples in the lab, but it also provides the particle size and shape distributions of the drilling mud particles being cleaned out.